The first thing you need to do when bleeding a floor jack is to locate the bleed screw. It’s typically located on the side of the jack and is a small plug. Once you’ve located the bleed screw, make sure the jack is fully lowered and the handle is in the locked position. You’ll also need to make sure the jack is on a level surface.
Now, it’s time to bleed the jack. The first step is to turn the bleed screw counter-clockwise. You should hear air escaping from the screw. Keep turning the screw and let the air escape until you see fluid start to leak out. Once you see fluid, you can stop turning the screw.
Now, it’s time to add fluid to the jack. Make sure the jack is still in the fully lowered position and that the handle is still in the locked position. Find the fill plug on the jack and remove it. You’ll want to use hydraulic jack oil to fill the jack. Slowly pour the oil into the jack until it reaches the fill line. Replace the fill plug.
Once you’ve filled the jack with oil, it’s time to bleed it again. Turn the bleed screw counter-clockwise and let the air escape. Keep turning the screw until you see fluid start to leak out. Once you see fluid, stop turning the screw and tighten it back up.
Now, it’s time to test the jack. Pump the handle of the jack a few times to make sure it’s working properly. If it is, you’re all set! If it’s not, you may need to bleed the jack again.
In conclusion, bleeding a floor jack is an essential task for anyone who wants to work on their car. By following the steps listed above, you can ensure that you’re doing it safely and correctly. Remember to always work on a level surface and to use hydraulic jack oil. With these tips in mind, you’ll be able to safely and effectively bleed your floor jack any time you need to.
Keywords: Push type floor socket, floor jack, bleed screw, hydraulic jack oil, fill plug, level surface